Email: Gustavo@hengrytech.com Tel: +86-577-67318236


HRB-507 Building Power Supply, Distribution and Lighting System Trainer

Technical parameters:
1、 Input power supply: three-phase four-wire ~ 380V ± 10% 50Hz
2、 Device capacity: <5kVA
3、 Model: 600X500X1600mm
4、 External dimensions; 1800X600X1800mm
5、 Safety protection: with leakage protection

Product Description:

Product Overview:

This device consists of building power supply and distribution lines, control appliances: miniature circuit breakers, etc., the site set the instrumentation measurement unit, voltage and current display, the use of intelligent power collection module: voltage, current power, electrical energy, etc., and through the bus to complete the upper computer of the various circuit power display.

Building lighting control part consists of building lighting lines, and set up lighting control switches, including traditional switches, remote control switches and intelligent dimming devices, equipped with the upper computer monitoring system, real-time monitoring of the power supply and distribution network structure, but also can monitor the lighting system, control lighting lines, suitable for all kinds of vocational education and training institutions teaching.


Practical training projects


Power supply and distribution system part:

1. Instrumentation equipment training project

(1) Commonly used power supply and distribution equipment knowledge and application

(2) Cognition and application of power sensors

2. Line installation, commissioning and operation training

(1) Intelligent building power supply operation line set up and operation

(2) Typical floor power distribution line set up and operation

(3) On-site monitoring, meter-reading and control of power supply and distribution system operating line status.

3. Power supply and distribution automation equipment cognition and operation control training

(1) Self-injection linkage operation control and regulation

(2) Emergency power distribution line operation and linkage control

(3) Distribution line power factor compensation operation control

4. Power supply and distribution system integrated control operation training

(1) Power supply and distribution monitoring system operation scheduling

(2) Linkage control with automatic fire alarm system

Lighting system part:

1. Lighting and control equipment awareness and application of practical training projects

(1) knowledge and application of common lamps and lanterns

(2) illumination sensor awareness and application

(3) motion detector awareness and application

(4) Remote lighting controller knowledge and application

2. General lighting control line installation and debugging training projects

(1) lighting fixtures and general control equipment installation and commissioning control

(2) emergency lighting equipment control

3. Intelligent lighting control line installation and commissioning training project

(1) schedule control mode lighting line set up and control

(2) lighting line formation and control under the scenario switching control mode

(3) Remote forced control mode lighting line set up and control

(4) dynamic control mode lighting line formation and control

4. Integrated scheduling control part

(1) Joint monitoring of power supply and distribution subsystems and lighting subsystems

(2) Joint monitoring of power supply and distribution subsystems, lighting subsystems and other building subsystems.


Inquiry:
Leave a message

 
Top